MacroQuest64

Hey all-

I did use search. I'm using this ver of genbot so posting question here. I box 6 toons, 1 is master 5 bots thanks to genbot. I only have one issue. I have a zerker that will not autoengage. It doesnt matter what box I try this toon on. (all same compiled mq2 AND ini file anyways) I /gs assist. All toons acquire my target and turn on attack. Then all but the zerker autoengage. Autoengage should work if mob is in range (is) and attack is on, correct? Autoengage is set to on in the ini file. For $hits and giggles I've tried toggling it on and off.

Just tried again last night on a box that was just reimaged. Fresh install of eq, so the ui is box stock. Any suggestions?

I can make him autofollow his target, he does start swinging then. But typically i just try to pull where the other toons push mob into a corner where the zerker is already standing.

Thanks for any input
Naots Cantare
E'Marr

say assist me and see if that works

If thats your server/character name, you may want to get rid of it in the post, or getting your berzerker to autoengage might be the least of your worries.

or getting your berzerker to autoengage might be the least of your worries.

haha

or getting your berzerker to autoengage might be the least of your worries

/snigger

Make sure you have

melee=on

in the [Combat] section of your bot_Playername.ini file.

Hope it makes it happen for you.