${spawn} question.
Posted: Fri May 14, 2004 9:15 am
Im convertiing over one of my macros and ive run into an issue, ive search and look at probably every macro in the depo and conversion thread but havent seen any1 that uses ${spawn} like me yet....
so what is wrong with this line?
/varset PullMobID ${Spawn[npc radius 3 loc ${Mob1}].ID}
In my old macro i used to just have it with npc and loc but with the dx9 change i find that mobs dont reset to their original loc they seem to be a weee bit off if u have to fd and wait for reset etc
With that line it isnt finding any mob at that location or within that radius, loc is Y:X right? although i think ive tryed it both ways.
Thanx in advance.
so what is wrong with this line?
/varset PullMobID ${Spawn[npc radius 3 loc ${Mob1}].ID}
In my old macro i used to just have it with npc and loc but with the dx9 change i find that mobs dont reset to their original loc they seem to be a weee bit off if u have to fd and wait for reset etc
With that line it isnt finding any mob at that location or within that radius, loc is Y:X right? although i think ive tryed it both ways.
Thanx in advance.
