${spawn} question.

kabl2k · Post by **kabl2k** » Fri May 14, 2004 9:15 am

Im convertiing over one of my macros and ive run into an issue, ive search and look at probably every macro in the depo and conversion thread but havent seen any1 that uses ${spawn} like me yet....

so what is wrong with this line?

/varset PullMobID ${Spawn[npc radius 3 loc ${Mob1}].ID}

In my old macro i used to just have it with npc and loc but with the dx9 change i find that mobs dont reset to their original loc they seem to be a weee bit off if u have to fd and wait for reset etc

With that line it isnt finding any mob at that location or within that radius, loc is Y:X right? although i think ive tryed it both ways.

Thanx in advance.

Lax · Post by **Lax** » Fri May 14, 2004 1:09 pm

if you say "any1" one more time im going to ban you, just so that's clear, and I'm not kidding about that

it looks like it doesnt work because of an issue in the spawn searching.. I'll look into it, try it next zip.

kabl2k · Post by **kabl2k** » Fri May 14, 2004 3:19 pm

lol dont like shorform ??? hehe its second nature to me go easy too many years on irc.....