Having MQ performance problems after 5/5 patch

tbigg · Post by **tbigg** » Fri May 07, 2004 1:06 am

One of the PCs I run MQ on is an old PII system with an Intel 810 graphics chip (unaccellerated). I have it optimized for macro performance (no sound, low clip plane, low res graphics, etc.) Until the last patch on 5/5, it has worked quite well, especially after Sony sorted out all the Dx9 issues.

But the last patch has caused my macro to run about 15x slower. The only plugins I have loaded are:

mq2fps (with low fps set)
mq2chatwnd
mq2itemdisplay
mq2labels

I do not notice lower performance in EQ when I have MQ unloaded, so I am assuming it is something with MQ.

Any ideas or suggestions?

Thanks

Lax · Post by **Lax** » Fri May 07, 2004 1:10 am

Try this...
/caption player4

tbigg · Post by **tbigg** » Fri May 07, 2004 1:36 am

You da man, Lax. That did it.

I'll look through the release to see if I can figure out what that did, but for now I'm happy.

Lax · Post by **Lax** » Fri May 07, 2004 1:45 am

New feature. All currently reported performance issues are related to this so I'm going to be looking at speeding it up a bit underneath and/or having it disabled by default.