Changing Read-only Tag / mqauth error

wizar · Post by **wizar** » Sun Jan 25, 2004 6:19 pm

Thank Mr Bob using a floppy worked. Using the same file and emailing to my main comp did not. Something is corrupt there.

Lax · Post by **Lax** » Tue Feb 03, 2004 4:52 am

little late to post on this but ... read only flag? Wasn't aware of anything like that

anyway about mq2auth...
each computer you run mq2auth on adds two lines to MQ2Auth0.h, creating it if it does not exist. The method used doesn't matter, but the two lines from each computer must exist in the final MQ2Auth0.h, at the time it is compiled into MQ2. The "final" MQ2Auth0.h must be in the MQ2Main directory.

If something were to be "corrupt", it would not "compile". So, the only things left are a) MQ2Auth0.h did not make its way back into MQ2Main directory (and you only compiled with the compiling computer's info!), b) The compile took place before MQ2Auth0.h was updated, c) Separate copies of MQ2Auth0.h were actually used...

Since you said 8 lines in the MQ2Auth0.h, my best guesses would be a and/or b.

wassup · Post by **wassup** » Tue Feb 03, 2004 6:31 am

Yeah Lax... every time I extract the MQ2-Latest.zip all of the files are set to read only for some reason.

I know I am not changing the flags to read only.

Mckorr · Post by **Mckorr** » Tue Feb 03, 2004 7:54 am

Actually I've seen the read-only problem pop up a time or two when I've updated my source from the zip file instead of the CVS for whatever reason. I haven't had any problems resetting things though.

Lax · Post by **Lax** » Tue Feb 03, 2004 2:30 pm

Ok, I blame whoever did the last zip then