quick question

[macrolover]

is there a way to make a macro that buys supplies in one zone. then zones to another to buy deferent supplies. for example npc in zone 1 sells batwings npc in zone two sells fresh fish. what i want to do is program a macro that buys the batwings zones buy's fish then combines.then goes back to batwings vendor and starts again. is this possible and how would i go about doing it.don't want a full macro unless you have one already made that does this if so pm me with it. Any help or examples will be appreciated.

[GD]

Yes, it can be done, you'd just have to tell it to run to specific waypoints till it gets near the zone, then have it walk to a location past the zone line. Then, you'd have to tell it to load up new waypoints, etc. once it finishes zoning.

Am I going to write you the code to do this? No, because this would be a good learning experience for you to do on your own, and I have no desire to write public code which could be abused.

[macrolover]

just wondering how you would find out if you zoned

[Xaanin]

hmm... how about Event zone "You have entered"

Or you can have it load different waypoints depending on what the $zone variable returns.

[FlashG]

or you could, if $zone=="zonenamehere" then delay and loop till you are in the zone. GL

[azwildfire]

right now MQ crahes if i zone with a macro running .. no matter what macro it is. kinda sucks