Cmd failed to open

sovietax · Post by **sovietax** » Thu May 24, 2007 2:55 pm

I tried 3 different times from start to finish starting fresh everytime and i alway get the same result. when I go to compile MQ2main it gets to the end and i get the error Project : error PRJ0003 : Error spawning 'cmd.exe'.
I have lookin in the forums and the wiki and there is nothing on this subject. i was using the VS express to compile MQ2. any ideas?

[[Compiling Problems]]
I added in this information and gave some suggestions on trying different things... they didnt work for me but might work for others. When I find out how I fix this then I will add that in there as well

dont_know_at_all · Post by **dont_know_at_all** » Thu May 24, 2007 4:26 pm

http://www.interact-sw.co.uk/iangblog/2 ... spawnerror

sovietax · Post by **sovietax** » Fri May 25, 2007 12:42 pm

i checked my directories like it says and all of mine are $ and not %. i dont know how to use that command line or where to put it. i use the check button and no errors came up for the directories....i got it now thanx, those entries needed to be added in as well

xyilla · Post by **xyilla** » Wed Aug 13, 2025 12:57 am

xyilla · Post by **xyilla** » Wed Aug 13, 2025 12:58 am

xyilla · Post by **xyilla** » Wed Aug 13, 2025 12:59 am

xyilla · Post by **xyilla** » Wed Aug 13, 2025 1:00 am

xyilla · Post by **xyilla** » Wed Aug 13, 2025 1:02 am

xyilla · Post by **xyilla** » Wed Aug 13, 2025 1:03 am

Cmd failed to open

Cmd failed to open

Re: Cmd failed to open

Re: Cmd failed to open

Re: Cmd failed to open

Re: Cmd failed to open

Re: Cmd failed to open

Re: Cmd failed to open